Page 33 - CanaDream 2025 DVC English
P. 33
OPERATING SYSTEMS IN THE RV
MICROWAVE FURNACE
The RV microwave operates on 110-Volt power only. The RV To operate the RV furnace with the Truma Control Center:
must be plugged into a campsite power pole or the generator must
be running for it to turn on. The microwave in the RV will operate See FIGURE 18: TRUMA CONTROL CENTER – FURNACE on this page.
similar to your household microwave.
1. Push the rotary knob in if the Truma display is not active.
Troubleshooting: see TABLE 11: MICROWAVE on page 45. The knob may need to be held in for 3 seconds.
ROOF AIR CONDITIONER 2. Turn the rotary knob to select the RV icon and press to confirm
selection.
The roof air conditioner will only operate when the RV is plugged
into a campsite power pole or the generator is running. The roof air 3. Turn the rotary knob to select the desired temperature and
conditioner does not operate while the RV is in motion. press to confirm selection. The display will flash until the
selected temperature is reached. Your furnace will now be
The controls are on the air conditioner which is mounted on the operational and requires no further setting adjustments.
ceiling.
Troubleshooting: See TABLE 6: FURNACE on page 43.
1. There are settings for both high and low fan speeds, as well
as high and low air conditioning (AC). The fan provides air CAUTION
circulation, while the AC settings will provide cold air. Furnace vents on the outside of RVs can become
EXTREMELY HOT. Use CAUTION when parking to ensure there
2. Set the temperature dial to the preferred cold setting. Red is for are no trees or flammable objects close. Keep children and hands
a higher ambient temperature, and blue is for a lower ambient away. Never lean personal articles near or against the vent.
temperature. For optimal cooling, turn the dial to the blue
setting. The AC system does not provide heat; for heat, please Truma Panel reset for malfunction or error codes:
refer to the furnace instructions.
1. Locate WRENCH (service menu) icon bottom right of screen,
Troubleshooting: see TABLE 12: ROOF AIR CONDITIONER on turn rotary push button to right until the WRENCH icon is
page 45. selected, tap the rotary push button to access menu.
TIP 2. Turn the rotary push button to the right, until “RESET” is
If you notice water running off of the RV roof while displayed, tap rotary push button.
running your rooftop air conditioner do not be alarmed.
This condensation run off is normal. 3. “PR SET” shows on display, tap the rotary push button to
initialize reset.
4. The screen should show "INIT..." for a few seconds. Once the
reset is complete, the screen should display the main menu.
Resetting the Truma panel will adjust all settings to default, and
the hot water system and furnace system will need to be set to
respective ON settings.
TIP
It is recommended to run the Truma system only on the
propane (GAS) energy mode setting to avoid interruption to
the system.
FURNACE HOT WATER ENERGY MODE CAUTION
VENT When the furnace is running the water in the RV's Truma
system may consecutively heat up. Use caution while operating
the water system if the furnace is running.
SERVICE MENU
ROTARY KNOB
FIGURE 18: TRUMA CONTROL CENTER – FURNACE CANADREAM.COM 33
DVC
MICROWAVE FURNACE
The RV microwave operates on 110-Volt power only. The RV To operate the RV furnace with the Truma Control Center:
must be plugged into a campsite power pole or the generator must
be running for it to turn on. The microwave in the RV will operate See FIGURE 18: TRUMA CONTROL CENTER – FURNACE on this page.
similar to your household microwave.
1. Push the rotary knob in if the Truma display is not active.
Troubleshooting: see TABLE 11: MICROWAVE on page 45. The knob may need to be held in for 3 seconds.
ROOF AIR CONDITIONER 2. Turn the rotary knob to select the RV icon and press to confirm
selection.
The roof air conditioner will only operate when the RV is plugged
into a campsite power pole or the generator is running. The roof air 3. Turn the rotary knob to select the desired temperature and
conditioner does not operate while the RV is in motion. press to confirm selection. The display will flash until the
selected temperature is reached. Your furnace will now be
The controls are on the air conditioner which is mounted on the operational and requires no further setting adjustments.
ceiling.
Troubleshooting: See TABLE 6: FURNACE on page 43.
1. There are settings for both high and low fan speeds, as well
as high and low air conditioning (AC). The fan provides air CAUTION
circulation, while the AC settings will provide cold air. Furnace vents on the outside of RVs can become
EXTREMELY HOT. Use CAUTION when parking to ensure there
2. Set the temperature dial to the preferred cold setting. Red is for are no trees or flammable objects close. Keep children and hands
a higher ambient temperature, and blue is for a lower ambient away. Never lean personal articles near or against the vent.
temperature. For optimal cooling, turn the dial to the blue
setting. The AC system does not provide heat; for heat, please Truma Panel reset for malfunction or error codes:
refer to the furnace instructions.
1. Locate WRENCH (service menu) icon bottom right of screen,
Troubleshooting: see TABLE 12: ROOF AIR CONDITIONER on turn rotary push button to right until the WRENCH icon is
page 45. selected, tap the rotary push button to access menu.
TIP 2. Turn the rotary push button to the right, until “RESET” is
If you notice water running off of the RV roof while displayed, tap rotary push button.
running your rooftop air conditioner do not be alarmed.
This condensation run off is normal. 3. “PR SET” shows on display, tap the rotary push button to
initialize reset.
4. The screen should show "INIT..." for a few seconds. Once the
reset is complete, the screen should display the main menu.
Resetting the Truma panel will adjust all settings to default, and
the hot water system and furnace system will need to be set to
respective ON settings.
TIP
It is recommended to run the Truma system only on the
propane (GAS) energy mode setting to avoid interruption to
the system.
FURNACE HOT WATER ENERGY MODE CAUTION
VENT When the furnace is running the water in the RV's Truma
system may consecutively heat up. Use caution while operating
the water system if the furnace is running.
SERVICE MENU
ROTARY KNOB
FIGURE 18: TRUMA CONTROL CENTER – FURNACE CANADREAM.COM 33
DVC
